

A valid binary configuration file reduces the overall boot time significantly. Note Each time a copy running-config startup-config command is issued, a binary file is created and the ASCII file is updated. Use the following command to download a configuration file from a remote server to the running configuration: The configuration file downloads and the commands are executed as the file is parsed line by line. Step 2 Configure the switch using the configuration file downloaded from the remote server using the copy scheme://urlsystem:running-config command, where scheme is TFTP, FTP, SCP, or SFTP and url is the path to the source file on the remote server. Step 1 Log into the switch through the console port or through a Telnet or SSH session. To configure a switch in the Cisco MDS 9000 Family using a configuration file downloaded from a remote server using TFTP, FTP, SCP, or SFTP, follow these steps: The switch and the remote server must be in the same subnetwork if you do not have a router or default gateway to route traffic between subnets.Ĭheck connectivity to the remote server using the ping command. Ensure the switch has a route to the remote server.Permissions on the file should be set to world-read. Ensure that the permissions on the file are set correctly.In addition, you can store configuration files on a bootflash device on the supervisor module and you can configure the switch using a configuration stored on an external CompactFlash disk.īefore you begin downloading a configuration file using a remote server, do the following:Įnsure the configuration file to be downloaded is in the correct directory on the remote server. You can configure a switch in the Cisco MDS 9000 Family by using configuration files you create or download from another switch. Ip domain-name Downloading Configuration Files to the Switch
